Using the File System
3–58
TDS 340A, TDS 360 & TDS 380 User Manual
To turn on or off the confirm delete message, toggle the side-menu button
Confirm Delete.
When the confirm delete option is OFF, the oscilloscope can immediately delete
files or directories. When the confirm option is ON, the oscilloscope warns you
before it deletes files and gives you a chance to reconsider.
To turn on or off the file overwrite lock, toggle the side-menu button Overwrite
Lock.
When overwrite lock is on, the oscilloscope will not permit you to write over an
existing file of the same name. An important reason to allow overwriting is to let
you write files using a target file name that contains wild card characters (“?”).
This means the oscilloscope creates sequential files whose names are similar
except for the sequential numbers that go in the real name in the place of the
question marks.
To format a 720 Kbyte or 1.44 Mbyte disk, turn the general purpose knob until it
scrolls the cursor over the name of the drive to format in. (fd0:) Then, press the
side-menu button Format.
See Making Hard Copies, on page 3–41.
See Saving and Recalling Front-Panel Setups, on page 3–51.
See Saving and Recalling Waveforms, on page 3–45.
Setting Confirm Delete
Setting Override Lock
Formatting a Disk
For More Information
To Next Page
Loading...
Need help?
General
