EasyManuals Logo

Tektronix TDS 340A User Manual

Tektronix TDS 340A
164 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #117 background imageLoading...
Page #117 background image
Appendix A: Specifications
TDS 340A, TDS 360 & TDS 380 User Manual
A–5
Typical Characteristics
Typical characteristics are described in terms of typical or average performance.
Typical characteristics are not warranted.
Table A–6: Typical characteristics — signal acquisition system
Name Description
Accuracy, DC Gain, Envelope
Acquisition Mode
±3% for sec/div settings from 5 Sec/Div to 25 msec/div;
±2% for sec/div settings from 10 ms/div to 5 ns/div (TDS 340A);
±2% for sec/div settings from 10 ms/div to 2.5 ns/div (TDS 360);
±2% for sec/div settings from 10 ms/div to 1 ns/div (TDS 380)
Acc
u
r
a
c
y
,
DC V
olt
ag
e
M
e
a
s
u
reme
n
t,
S m le Ac isitio o e
Measurement type DC accuracy
S
a
m
p
le
Ac
qu
isitio
n M
o
d
e
Any Sample ±(2.0% × (|reading – Net Offset
1
|) + Offset
Accuracy + 0.13 div + 0.6 mV)
Delta Volts between any two samples
2
acquired under the same setup and
ambient conditions
±(2.0% × |reading| + 0.26 div + 1.2 mV)
Frequency Limit, Upper, 20 MHz Band-
width Limited
20 MHz
Ste
p R
es
p
o
n
se
Settli
ng E
rror
Vo
l
ts/D
iv
eig
St
ep
a pli e
Settling error (%)
3
s
e
tt
i
n
g
a
m
pli
tud
e
100 ns 20 ms
2 mV/div – 99.5 mV/div 2 V 1.0 0.1
100 mV/div – 995 mV/div 20 V 1.5 0.2
1 V/div – 10 V/div 200 V 2.5 0.2
Common Mode Rejection Ratio (CMRR) 100:1 at 60 Hz, reducing to 20:1 at 50 MHz, with equal Volts/Div and Coupling settings
on each channel.
1
Net Offset = Offset – (Position × Volts/Div). Net Offset is the voltage level at the center of the A-D converter dynamic
range. Offset Accuracy is the accuracy of this voltage level.
2
The samples must be acquired under the same setup and ambient conditions.
3
The values given are the maximum absolute difference between the value at the end of a specified time interval after the
mid-level crossing of the step, and the value one second after the mid-level crossing of the step, expressed as a
percentage of the step amplitude.

Table of Contents

Other manuals for Tektronix TDS 340A

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tektronix TDS 340A and is the answer not in the manual?

Tektronix TDS 340A Specifications

General IconGeneral
BrandTektronix
ModelTDS 340A
CategoryTest Equipment
LanguageEnglish

Related product manuals