EasyManua.ls Logo

Tektronix TDS5000B Series

Tektronix TDS5000B Series
237 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Removal and Inst a l l a t i on Procedures
6-- 48
TDS5000B Series Se r vi c e Manual
1. Locate module to be removed: Locate the Acquisition board in the locator
diagram, Figure 6-- 7, on page 6--19. Additional modul e s to be removed:
! Trim (all)
! Bottom cover
2. Orient the osci l l osc ope : Set the oscilloscope so the top is down on t he work
surface and t he bottom is facing up.
3. Remove the A c qui si t i on board: See Figure 6--27, page 6--49.
a. Remove the seve n T-15 TORX drive screws that secure the bottom panel
to the chassis.
b. Di sc onne c t the three coaxial cable s from the Acquisition board.
c. Disconne c t the ribbon cable from the Acquisition board.
d. Re m ove the six T-15 TORX drive screws that secure the board to the
chassis.
e. Remove the six T--15 TORX drive screws that secure the board to the
front panel.
f. Grasp the Acquisi t i on board on the edge ne a r J1800 (see Figure 6--27)
and carefully pull the boar d up to disconnect J1800. Once you have
cleared the connector, remove the board from the chassis.
4. Reinstallation:
a. When installing the Acquisition board, set the board in place and align
the J1800 halves using the guide pin. Gent l y press the board into place to
seat the conne c t or between the PC interface board and the Acquisition
board.
b. I nst a l l the six T-15 TORX drive screws that secure the Acquisition board
to the front panel.
c. Insta l l the six T-15 TORX drive screws that secure the Acquisition board
to the chassis.
d. Conne c t the three coaxial cables to the Acquisition board.
Acquisition Board

Table of Contents

Other manuals for Tektronix TDS5000B Series

Related product manuals