Operating Basics
TDS5000B Series Quick Start User Manual
81
6. Click Config to set up the Failure
Notification.
7. Select the Failure Notification(s),
andthenclickClose to return to
the setup control window.
8. Click Lock Template to Waveform
On to lock the vertical scale or
position of the template to that of
the source waveform.
9. Click Highlight Hits On to show
points that fall outside the tem-
plate in a differe nt color.
6
7
8
9
10. Click On to start the test.
11. Click Reset to clear all violations
and reset the test.
10
11
Quick Tips
H You can use active or saved waveforms to create a limit test template.
H Using Average acquisition mode will create a smoother template waveform.
H Using Envelope acquisition mode will create a template that allows for occasional overshoots.
To Next Page
Loading...
