Teledyne 400E - Viewing Existing Data Channels

Model 400E Ozone Analyzer
Instruction Manual
Operating Instructions
P/N 04316 Rev: B 149
6.11.5. Viewing Existing Data Channels
The data in the default Data Channels can be viewed through the following
keystroke sequence:
SAMPLE RANGE = 500.0 PPB O3 =XXX.X
< TST TST > CAL
SETUP
SETUP X.X
CONC
: DATA AVAILABLE
NEXT VIEW EXIT
SETUP X.X PNUMTC: DATA AVAILABLE
PREV NEXT VIEW EXIT
SETUP X.X O3GEN: DATA AVAILABLE
PREV
VIEW
EXIT
SETUP X.X 00:00:00 SLOPE1=0.000
PV10 PREV <PRM PRM> EXIT
SETUP X.X 00:00:00 CONC1=0.0 PPM
PV10 PREV NEXT NX10 EXIT
SETUP X.X 00:00:00 SMPFLW=000.0 cc / m
<PRM PRM> EXIT
SETUP X.X DATA ACQUISITION
VIEW
EDIT EXIT
SETUP X.X
CFG DAS RNGE PASS CLK MORE EXIT
VIEW KEYPAD FUNCTIONS
KEY FUNCTION
<PRM Moves to the next Data
Parameter
PRM> Moves to the previous Data
Parameter
NX10 Moves to view pointer forward
10 data points/channels
NEXT Moves to the next data
point/channel
PREV Moves to the previous data
point/channel
PV10 Moves to the backward 10
data points/channels
NOTE: Keys only appear as needed
EXIT will go back to
previous menu
returning to the main
SAMPLE Display.