Teledyne 400E - Configuring the Data Parameter Functions

Model 400E Ozone Analyzer
Instruction Manual
Operating Instructions
P/N 04316 Rev: B 155
6.12.5. Configuring the Data Parameter Functions
To configure the parameters for a specific Data Parameter, press:
FROM THEEDIT DATA PARAMETER MENU
SETUP X.X 0) PARAM=DETREP, MODE=INST
PREV NEXT INS DEL EDIT EXIT
SETUP X.X PARAMETERS: DETREF
SET> EDIT EXIT
SETUP X.X SAMPLE MODE: INST
<SET SET> EDIT EXIT
SETUP X.X PARAMETERS: DETREF
PREV NEXT ENTR EXIT
PREV & NEXT Cycle through list of
available Data Parameters.
CHANGING THE PARAMETER TYPE
DELETES ALL RECORDED DATA
ENTR
accepts the new
setting and returns to the
previous menu.
EXIT
ignores
the new setting
and returns to the previous
menu.
SETUP X.X SAMPLE MODE: INST
INST AVG MIN MAX EXIT
Press the key for the desired Mode
SETUP X.X PRECISION: 1
<SET SET> EDIT EXIT
SETUP X.X PRECISION: 1
1 EXIT
Toggle key to set for 0-9
SETUP X.X STORE NUM. SAMPLES: OFF
<SET EDIT EXIT
SETUP X.X
STORE NUM. SAMPLES: OFF
OFF ENTR EXIT
Toggle key to Turn ON/OFF
<SET
Returns to
previous
Functions