Teledyne 400E - Page 9

Model 400E Ozone Analyzer
Instruction Manual
Table of Contents
P/N 04316 Rev: B ix
LIST OF FIGURES
Figure 3-1: Location of Shipping Screws, Chassis Bottom View ............................................. 24
Figure 3-2: Rear Panel Connectors................................................................................... 29
Figure 3-3: Basic Pneumatic Connections Flow Diagram....................................................... 31
Figure 3-4: Pneumatic Connections Flow Diagram with Zero/Span Valve or IZS Options Installed
............................................................................................................... 32
Figure 3-5: Assembly Layout .......................................................................................... 42
Figure 5-1: Current Loop Option Installed ......................................................................... 48
Figure 5-2: Pneumatic Diagram – Zero/Span Valves ........................................................... 49
Figure 5-3: Pneumatic Diagram – Zero/Span Valves ........................................................... 51
Figure 5-4: M400E Ethernet Card and Rear Panel With Ethernet Installed ............................... 54
Figure 6-1: Front Panel Display ....................................................................................... 55
Figure 6-2: Setup for Calibrating Analog Output Signal Levels .............................................104
Figure 6-3: Setup for Checking Current Output Signal Levels...............................................106
Figure 6-4: Status Output Connector...............................................................................112
Figure 6-5: Control Inputs w/ Local 5 VDC Power Supply ....................................................114
Figure 6-6: Control Inputs w/ External 5 VDC Power Supply ................................................115
Figure 6-7: CPU card Locations of RS-232/486 Switches, Connectors and Jumpers ..................117
Figure 6-8: Default iDAS Channels Setup .........................................................................148
Figure 7-1: Pneumatic Connections for Manual Calibration without Z/S Valve or IZS Options....166
Figure 7-2: Pneumatic connections for Manual Calibration without Z/S Valve or IZS Options ....169
Figure 7-3: Pneumatic Connections for Manual Calibration With Z/S Valves............................171
Figure 7-4: Pneumatic connections for Manual Calibration Check with Z/S Valve or IZS Options
..............................................................................................................176
Figure 9-1: Replacing the Particulate Filter.......................................................................208
Figure 9-2: Replacing the IZS Zero Air Scrubber ...............................................................210
Figure 10-1: O
3
Absorption Path.....................................................................................220
Figure 10-2: Reference / Measurement Gas Cycle..............................................................220
Figure 10-3: Model 400E Pneumatic Operation..................................................................223
Figure 10-4: 400E Electronic Block Diagram.....................................................................226
Figure 10-5: Optical Bench Layout – Top View ..................................................................229
Figure 10-6: Photometer UV Lamp Power Supply Block Diagram..........................................230
Figure 10-7: Power Distribution Block Diagram.................................................................236
Figure 10-8: Interface Block Diagram..............................................................................237
Figure 10-9: Front Panel ...............................................................................................238
Figure 10-10: Basic Software Operation...........................................................................240
Figure 11-1: Viewing and Clearing Warning Messages ........................................................245
Figure 11-2: Example of Signal I/O Function.....................................................................249
Figure 11-3: CPU Status Indicator ..................................................................................250
Figure 11-4: Location of Relay Board Status LED’s .............................................................251
Figure 11-5: Critical Flow Orifice Assembly (Instruments without IZS) ..................................266
Figure 11-6: IZS Zero Air Scrubber Location.....................................................................268