145
4.13 DSL
This page allows you to configure DSL parameters. DSL parameters configuration should be based
on the parameters of the upstream device. Final parameters can be checked on Statistics-xDSL page.
Wrong configurations may fail your Internet access.
Change them only when you are instructed by your ISP or our technical staff when your modem
router fails to negotiate with ISP in DSL (ATM) mode. If the DSL LED indicator of the device keeps
blinking, DSL negotiation may fail.
Choose Advanced Setup > DSL to enter the configuration page.
Parameter description
It specifies G992.1. The maximum uploading/downloading rate is 1.3 Mbps/8
Mbps. When it is used, POTS splitter is required for clients.
It specifies G992.2. The maximum uploading/downloading rate is 512 Kbps/1.5
Mbps. When it is used, POTS splitter is NOT required for clients.
To Next Page
Loading...
