169
4.21.2 ETH interface
If your layer 2 interface is Ethernet Interface, perform the following procedure:
Step 1 Choose Advanced Setup > IPTV to enter the configuration page.
Step 2 Select Enable IPTV option.
Step 3 Select Ethernet Interface.
Step 4 Select a LAN port to serves as an IPTV port for connecting to the set-top box. The default
IPTV port is lan1 (port 1).
Step 5 Enter the 802.1P priority and 802.1Q VLAN ID values provided by your ISP.
Step 6 Click Apply/Save.
----End
4.21.3 PTM interface
If your layer2 interface is PTM Interface, perform the following procedure:
Step 1 Choose Advanced Setup > IPTV to enter the configuration page.
Step 2 Select Enable IPTV option.
Step 3 Select PTM Interface you create in Layer2 Interface.
Step 4 Select a LAN port to serves as an IPTV port for connecting to the set-top box. The default
IPTV port is lan1 (port 1).
Step 5 Enter the 802.1P priority and 802.1Q VLAN ID values provided by your ISP. This VLAN ID is
NOT the same as that of the WAN connection.
Step 6 Click Apply/Save.
To Next Page
Loading...
