Tenda V1200 - Access Control

217
7.7 Access control
This function allows you to use the HTTP, ICMP, SSH, TELNET, SNMP, FTP, TFTP and HTTPS to manage
the modem router from LAN or WAN side.
Choose Management > Access Control to enter the configuration page.
Parameter description
Parameter
Description
HTTP
After it is enabled, users can manage the modem router using HTTP protocol through
the browser from the corresponding sides (LAN or WAN). This method is acceptable
for most users.
ICMP
After it is enabled, it allows users to ping the modem router from the corresponding
sides (LAN or WAN) for connectivity diagnosis.
SSH
After it is enabled, users can manage the modem router through the Secure Shell
connection (SSH).
TELNET
After it is enabled, users can use TELNET to establish a connection with the device,
and visit the command-line interface of the device from the corresponding sides (LAN
or WAN).
SNMP
After it is enabled, the SNMP management software can establish a connection with
the device, and check some parameters of the device through MIB nodes from the
corresponding sides (LAN or WAN).
FTP
After it is enabled, the modem router servers as a server and users can use FTP
protocol to check, upload, or download files of the device from the corresponding
sides (LAN or WAN).