Tenda V1200 - MAC Filter

179
5.1.3 MAC filter
5.1.3.1 Overview
The MAC-based wireless access control feature can be used to allow or disallow clients to connect to your 2.4 GHz
wireless networks.
Choose Wireless > 2.4G > MAC Filter to enter the configuration page.
Parameter description
Parameter
Description
Select SSID
Select a SSID to which the rule is applied.
The rule is only applicable to the devices connected to the modem router wirelessly.
MAC Restrict Mode
Disabled: Disable this feature.
Allow: To allow only devices with specified MAC addresses (in the list) to connect to
your wireless network.
Deny: To disallow only devices with specified MAC addresses (in the list) to connect to
your wireless network.
MAC Address
The MAC address of a device to which a MAC filter rule is applied.
Add
Used to add a rule.
Remove
Used to remove the rule.
5.1.3.2 Adding a MAC filter rule
Step 1 Choose Wireless > 2.4G > MAC Filter to enter the configuration page.
Step 2 Select a SSID to apply the rule if you enable multiple SSIDs.
Step 3 Click Add.
Step 4 Enter the MAC address of the device to which the rule applies.