Tenda V1200 User Manual

215
Parameter
Description
Connection Request
Authentication
It specifies whether to authenticate the connection request sent by the ACS.
Connection Request
User Name
It specifies the user name used to authenticate the ACS when it sends the connection
request to the CPE.
Connection Request
Password
It specifies the password used to authenticate the ACS when it sends the connection
request to the CPE.
Connection Request
URL
It specifies the domain name used by the ACS when it sends the connection request
to the CPE. After the WAN port used by the TR-069 client is selected, this domain
name will be generated automatically.
7.5.2 Configuring the TR-069 Client
Step 1 Choose Management > TR-069 Client to enter the configuration page.
Step 2 Set Inform to Enable. By default, it is disabled.
Step 3 Set Inform Interval to the interval at which inform packets are sent.
Step 4 Set ACS URL to the URL of the ACS.
Step 5 Set ACS User Name to the user name of the ACS.
Step 6 Set ACS Password to the password of the ACS.
Step 7 Select the WAN port used by the TR-069 client from the WAN Interface used by TR-069
client drop-down list box.
Step 8 Set Display SOAP messages on serial console to Enable if SOAP messages must be
displayed on the serial console, or to disabled if SOAP messages do not need to be
displayed on the serial console.
Step 9 Select Connection Request Authentication if connection request authentication is
required.
If it is selected, perform the following steps:
1. Set Connection Request User Name to the user name for connection request
authentication.
2. Set Connection Request Password to the password for connection request authentication.
3. The Connection Request URL will be automatically generated after the WAN interface
used by the TR-069 client is selected.
Step 10 Click Apply/Save.
----End
To learn about the methods supported by the ACS, click GetRPCMethods.

Tenda V1200 Specifications

General

Brand	Tenda
Model	V1200
Category	Network Router
Language	English