189
If the wireless network of the modem router is not encrypted, or the wireless network is encrypted
but you forget or do not want to enter the complicated password, you can use WPS function to
encrypt or connect clients to it quickly. There are three options for you:
Option 1: PBC negotiation
Step 1 Choose Wireless > 5G > Security to enter the configuration page.
Step 2 Select Enabled to enable the function.
Step 3 Click Apply/Save on the bottom of this page.
Step 4 Press the WPS hardware button on the rear panel of the modem router for 3 seconds, and
then release it. (The WPS LED indicator starts blinking)
Step 5 Within 2 minutes, enable the WPS negotiation function on your wireless device.
----End
When the WPS LED turns to solid green, it indicates that the PBC negotiation is successful. The
wireless device is connected to the modem router, and the wireless network is encrypted.
Option 2: Using the WPS PIN code of the wireless device
Step 1 Log in to the web UI of the modem router, choose Wireless > 5G > Security to enter the
configuration page.
Step 2 Select Enabled to enable the function.
Step 3 Click Apply/Save on the bottom of this page.
Step 4 Select Enter STA PIN.
Step 5 Check the WPS PIN code on your wireless device and enter it to the blank box on the WPS
Setup page of the web UI.
To Next Page
Loading...
