62
PPPoA (Only for internet access through phone cable)
If the DSL Link Type is set to PPPoA when you create an ATM interface, refer to the following
procedure.
Step 1 Choose Advanced Setup > WAN Service to enter the following page, and click Add.
Step 2 Select ATM interface you create on the Layer2 Interface page, which is atm0/(0_0_35) in
this example, and click Next.
Step 3 Select your internet protocol, and click Next. IPv4 is used to illustrate here.
Step 4 Enter the user name and password provided by your ISP, set other parameters as required,
To Next Page
Loading...
