EasyManua.ls Logo

Texas Instruments C2000

Texas Instruments C2000
342 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
C2000™ Microcontroller Workshop
iv C2000 Microcontroller Workshop - Introduction
C2000™ Microcontroller Workshop Outline
C2000™ Microcontroller Workshop Outline
1. Architecture Overview
2. Programming Development Environment
Lab: Linker command file
3. Peripheral Register Header Files
4. Reset and Interrupts
5. System Initialization
Lab: Watchdog and interrupts
6. Analog-to-Digital Converter
Lab: Build a data acquisition system
7. Control Peripherals Lab: Generate and graph a PWM waveform
8. Numerical Concepts Lab: Low-pass filter the PWM waveform
9. Direct Memory Access (DMA) Lab: Use DMA to buffer ADC results
10. Control Law Accelerator (CLA) Lab: Use CLA to filter PWM waveform
11. Viterbi, Complex Math, CRC Unit (VCU)
12. System Design
Lab: Run the code from flash memory
13. Communications
14. Support Resources
Required Workshop Materials
Required Workshop Materials
http://processors.wiki.ti.com/index.php/
C2000_Piccolo_Multi-Day_Workshop
F28069 Experimenters Kit
(TMDXDOCK28069)
Install Code Composer Studio v6.0.0
Run the workshop installer
C2000 Microcontroller Workshop-5.0-Setup.exe
Lab Files / Solution Files
Student Guide and Documentation
The materials required for this workshop are available using the links shown at the top of this
slide. An F28069 Experimenter’s Kit and a jumper wire will be needed for the lab exercises. The

Table of Contents

Other manuals for Texas Instruments C2000

Related product manuals