16–4 Programming
82E978~1.DOC TI-83 international English Bob Fedorisko Revised: 10/26/05 1:47 PM Printed: 10/27/05 3:02
PM Page 4 of 22
A program is a set of one or more command lines. Each line
contains one or more instructions. When you execute a program,
the TI-82 STATS performs each instruction on each command
line in the same order in which you entered them. The number
and size of programs that the TI-82 STATS can store is limited
only by available memory.
To create a new program, follow these steps.
1. Press | to display the
PRGM NEW menu.
2. Press Í to select 1:Create New. The Name= prompt is
displayed, and alpha-lock is on.
3. Press a letter from A to Z or q to enter the first character of
the new program name.
Note: A program name can be one to eight characters long. The
first character must be a letter from A to Z or q. The second
through eighth characters can be letters, numbers, or q.
4. Enter zero to seven letters, numbers, or q to complete the
new program name.
5. Press Í. The program editor is displayed.
6. Enter one or more program commands (page 16.5).
7. Press y [
QUIT] to leave the program editor and return to
the home screen.
To check whether adequate memory is available for a program
you want to enter, press y [
MEM], and then select
1:Check RAM from the MEMORY menu (Chapter 18).
To increase available memory, press y [MEM], and then select
2:Delete from the MEMORY menu (Chapter 18).
To delete a specific program, press y [
MEM], select 2:Delete
from the MEMORY menu, and then select 7:Prgm from the
DELETE FROM secondary menu (Chapter 18).
Creating and Deleting Programs
What Is a
Program?
Creating a New
Program
Managing
Memory and
Deleting a
Program
To Next Page
Loading...
