19–6 Communication Link
825A7D~1.DOC TI-83 Intl English, Chap 19 Bob Fedorisko Revised: 10/27/05 1:26 PM Printed: 10/27/05 3:07
PM Page 6 of 10
To transmit selected items after you have selected items to send
on the sending unit (page 19
.4) and set the receiving unit to
receive (page 19
.5), follow these steps.
1. Press ~ on the sending unit to display the TRANSMIT menu.
2. Confirm that Waiting... is displayed on the receiving unit,
which indicates it is set to receive (page 19
.5).
3. Press Í to select 1:Transmit. The name and type of each
item are displayed line by line on the sending unit as the item
is queued for transmission, and then on the receiving unit as
each item is accepted.
After all selected items have been transmitted, the message
Done is displayed on both calculators. Press } and † to scroll
through the names.
To stop a link transmission, press É. The
Error in Xmit menu is
displayed on both units. To leave the error menu, select
1:Quit.
A transmission error occurs after one or two seconds if:
• A cable is not attached to the sending unit.
• A cable is not attached to the receiving unit.
Note: If the cable is attached, push it in firmly and try again.
• The receiving unit is not set to receive transmission.
• You attempt a backup between a TI
-82 and a TI-82 STATS.
• You attempt a data transfer from a TI-82 STATS to a TI
-82
with data other than lists L1 through L6 or without using
menu item 5:Lists to TI82.
Although a transmission error does not occur, these two
conditions may prevent successful transmission.
• You try to use
Get( with a calculator instead of a CBL or
CBR.
• You try to use
GetCalc( with a TI-82 instead of a
TI-82 STATS.
Transmitting Items
Transmitting
Items
Stopping a
Transmission
Error Conditions
To Next Page
Loading...
Need help?
General
