Texas Instruments TI-82 STATS

11–6 Lists
826886~1.DOC TI-83 international English Bob Fedorisko Revised: 10/26/05 1:33 PM Printed: 10/27/05 2:50
PM Page 6 of 18
To display the LIST NAMES menu, press y [LIST]. Each item is
a user-created list name.
LIST NAMES menu items are sorted
automatically in alphanumerical order. Only the first 10 items are
labeled, using
1 through 9, then 0. To jump to the first list name
that begins with a particular alpha character or q, press ƒ
[letter from A to Z or
q ].
Tip: From the top of a menu, press } to move to the bottom. From
the bottom, press † to move to the top.
Note: The LIST NAMES menu omits list names L1 through L6. Enter
L1 through L6 directly from the keyboard (page 11.3).
When you select a list name from the LIST NAMES menu, the
list name is pasted to the current cursor location.
• The list name symbol Ù
ÙÙ
Ù precedes a list name when the name
is pasted where non-list name data also is valid, such as the
home screen.
• The Ù
ÙÙ
Ù symbol does not precede a list name when the name is
pasted where a list name is the only valid input, such as the
stat list editor’s Name= prompt or the stat plot editor’s XList:
and YList: prompts.
To enter an existing list name directly, follow these steps.
1. Press y [
LIST] ~ to display the LIST OPS menu.
2. Select B:Ù
ÙÙ
Ù, which pastes Ù
ÙÙ
Ù to the current cursor location. Ù
ÙÙ
Ù is
not always necessary (page 11.16).
Note: You also can paste Ù
ÙÙ
Ù to the
current cursor location from the
CATALOG (Chapter 15).
3. Enter the characters that comprise the list name.
Entering List Names
Using the
LIST NAMES
Menu
Entering a User-
Created List
Name Directly