19–2 Communication Link
825A7D~1.DOC TI-83 Intl English, Chap 19 Bob Fedorisko Revised: 10/27/05 1:26 PM Printed: 10/27/05 3:07
PM Page 2 of 10
Getting Started is a fast-paced introduction. Read the chapter for details.
Create and store a variable and a matrix, and then transfer them to another
TI-82 STATS.
1. On the home screen of the sending unit, press
5 Ë 5 ¿ ƒ Q. Press Í to store
5.5 to
Q.
2. Press y [ [ ] y [ [ ] 1 ¢ 2 y [ ] ] y [ [ ]
3 ¢ 4 y [ ] ] y [ ] ] ¿ 1. Press
Í to store the matrix to
[A].
3. Connect the calculators with the link cable.
Push both ends in firmly.
4. On the receiving unit, press y [LINK] ~ to
display the
RECEIVE menu. Press 1 to select
1:Receive. The message Waiting... is
displayed and the busy indicator is on.
5. On the sending unit, press y [LINK] to
display the
SEND menu.
6. Press 2 to select 2:AllN. The AllN SELECT
screen is displayed.
7. Press † until the selection cursor ( 4 ) is next
to
[A] MATRX. Press Í.
8. Press † until the selection cursor is next to
Q REAL. Press Í. A square dot next to
[A] and Q indicates that each is selected to
send.
9. On the sending unit, press ~ to display the
TRANSMIT menu.
10. On the sending unit, press 1 to select
1:Transmit and begin transmission. The
receiving unit displays the message
Receiving....When the items are transmitted,
oth units display the name and type of each
transmitted variable.
Getting Started: Sending Variables
To Next Page
Loading...
Need help?
General
