19–10 Communication Link
825A7D~1.DOC TI-83 Intl English, Chap 19 Bob Fedorisko Revised: 10/27/05 1:26 PM Printed: 10/27/05 3:07
PM Page 10 of 10
To copy the exact contents of memory in the sending
TI-82 STATS to the memory of the receiving TI-82 STATS, put
the other unit in receive mode. Then, on the receiving unit,
select
C:Back Up from the LINK SEND menu.
• Warning:
C:Back Up overwrites the memory in the
receiving unit; all information in the memory of the
receiving unit is lost.
Note: If you do not want to do a backup, select 2:Quit to return to
the
LINK SEND menu.
• Select 1:Transmit to begin transmission.
As a safety check to prevent accidental loss of memory, the
message
WARNING . Backup is displayed when the receiving
unit receives notice of a backup.
• To continue with the backup process, select 1:Continue. The
backup transmission begins.
• To prevent the backup, select
2:Quit.
Note: If a transmission error is returned during a backup, the
receiving unit is reset.
When the backup is complete, both the sending calculator and
receiving calculator display a confirmation screen.
Backing Up Memory
Memory Backup
Receiving Unit
Memory Backup
Complete
To Next Page
Loading...
