Texas Instruments TI-82 STATS

Tables 7–3
82533C~1.DOC TI-83 international English Bob Fedorisko Revised: 10/26/05 1:24 PM Printed: 10/27/05 2:20
PM Page 3 of 6
To display the TABLE SETUP screen, press y [TBLSET].
TblStart (table start) defines the initial value for the independent
variable.
TblStart applies only when the independent variable is
generated automatically (when
Indpnt: Auto is selected).
@Tbl (table step) defines the increment for the independent
variable.
Note: In Seq mode, both TblStart and @Tbl must be integers.
Selections Table Characteristics
Indpnt: Auto
Depend: Auto
Values are dis
p
la
y
ed automaticall
y
in both the
inde
p
endent-variable column and in all
dependent-variable columns.
Indpnt: Ask
Depend: Auto
The table is em
p
t
y
; when
y
ou enter a value for
the inde
p
endent variable, all corres
p
ondin
g
de
p
endent-variable values are calculated and
displayed automatically.
Indpnt: Auto
Depend: Ask
Values are dis
p
la
y
ed automaticall
y
for the
inde
p
endent variable; to
g
enerate a value for a
de
p
endent variable, move the cursor to that
cell and press Í.
Indpnt: Ask
Depend: Ask
The table is em
p
t
y
; enter values for the
inde
p
endent variable; to
g
enerate a value for a
de
p
endent variable, move the cursor to that
cell and press Í.
To store a value to
TblStart, @Tbl, or TblZnput from the home
screen or a program, select the variable name from the
VARS
TABLE
secondary menu. TblZnput is a list of independent-
variable values in the current table.
When you press y [
TBLSET] in the program editor, you can
select
IndpntAuto, IndpntAsk, DependAuto, and DependAsk.
Setting Up the Table
TABLE SETUP
Screen
TblStart, @Tbl
Indpnt: Auto,
Indpnt: Ask,
Depend: Auto,
Depend: Ask
Setting Up the
Table from the
Home Screen or
a Program