1-24 Operating the TI-82 STATS
82STAT~3.DOC TI-83 international English Bob Fedorisko Revised: 10/28/05 12:11 PM Printed: 10/28/05 12:11
PM Page 24 of 24
The TI-82 STATS detects errors while performing these tasks.
• Evaluating an expression
• Executing an instruction
• Plotting a graph
• Storing a value
When the TI-82 STATS detects an error, it returns an error
message as a menu title, such as
ERR:SYNTAX or
ERR:DOMAIN. Appendix B describes each error type and
possible reasons for the error.
• If you select 1:Quit (or press y [QUIT] or ‘), then the
home screen is displayed.
• If you select
2:Goto, then the previous screen is displayed
with the cursor at or near the error location.
Note: If a syntax error occurs in the contents of a Y= function during
program execution, then the Goto option returns to the Y= editor, not
to the program.
To correct an error, follow these steps.
1. Note the error type (ERR:error type).
2. Select 2:Goto, if it is available. The previous screen is
displayed with the cursor at or near the error location.
3. Determine the error. If you cannot recognize the error, refer
to Appendix B.
4. Correct the expression.
Error Conditions
Diagnosing an
Error
Correcting an
Error
To Next Page
Loading...
