Operating the TI-82 STATS 1-15
82STAT~3.DOC TI-83 international English Bob Fedorisko Revised: 10/28/05 12:11 PM Printed: 10/28/05 12:11
PM Page 15 of 24
To recall and copy variable contents to the current cursor
location, follow these steps. To leave
RCL, press ‘.
1. Press y ãRCLä. Rcl and the edit cursor are displayed on the
bottom line of the screen.
2. Enter the name of the variable in any of five ways.
• Press ƒ and then the letter of the variable.
• Press y ã
LISTä, and then select the name of the list, or
press y [
Ln].
• Press , and then select the name of the matrix.
• Press to display the
VARS menu or ~ to
display the
VARS Y.VARS menu; then select the type and
then the name of the variable or function.
• Press |, and then select the name of the program
(in the program editor only).
The variable name you selected is displayed on the bottom
line and the cursor disappears.
3. Press Í. The variable contents are inserted where the
cursor was located before you began these steps.
Note: You can edit the characters pasted to the expression
without affecting the value in memory.
Recalling Variable Values
Using Recall
(RCL)
To Next Page
Need help?
General
