16–12 Programming
82E978~1.DOC TI-83 international English Bob Fedorisko Revised: 10/26/05 1:47 PM Printed: 10/27/05 3:02
PM Page 12 of 22
End identifies the end of a group of commands. You must
include an
End instruction at the end of each For(, While, or
Repeat loop. Also, you must paste an End instruction at the end
of each
If.Then group and each If.Then.Else group.
Pause suspends execution of the program so that you can see
answers or graphs. During the pause, the pause indicator is on in
the top-right corner. Press Í to resume execution.
•
Pause without a value temporarily pauses the program. If
the DispGraph or Disp instruction has been executed, the
appropriate screen is displayed.
•
Pause with value displays value on the current home screen.
value can be scrolled.
Pause [value]
Program Output
PRGM CTL (Control) Instructions (continued)
End
Pause
To Next Page
Loading...
Need help?
General
