Function Graphing 3.21
82533F~1.DOC TI-83 international English Bob Fedorisko Revised: 10/26/05 1:20 PM Printed: 10/27/05 1:55
PM Page 21 of 28
Zoom In magnifies the part of the graph that surrounds the
cursor location.
Zoom Out displays a greater portion of the
graph, centered on the cursor location. The
XFact and YFact
settings determine the extent of the zoom.
To zoom in on a graph, follow these steps.
1. Check XFact and YFact (page 3.24); change as needed.
2. Select 2:Zoom In from the ZOOM menu. The zoom cursor is
displayed.
3. Move the zoom cursor to the point that is to be the center of
the new viewing window.
4. Press Í. The TI-82 STATS adjusts the viewing window
by
XFact and YFact; updates the window variables; and
replots the selected functions, centered on the cursor
location.
5. Zoom in on the graph again in either of two ways.
• To zoom in at the same point, press Í.
• To zoom in at a new point, move the cursor to the point
that you want as the center of the new viewing window,
and then press Í.
To zoom out on a graph, select
3:Zoom Out and repeat steps 3
through 5.
To cancel
Zoom In or Zoom Out, press ‘.
ZDecimal replots the functions immediately. It updates the
window variables to preset values, as shown below. These
values set
@X and @Y equal to 0.1 and set the X and Y value of
each pixel to one decimal place.
Xmin=L4.7 Ymin=L3.1
Xmax=4.7 Ymax=3.1
Xscl=1 Yscl=1
ZSquare
replots the functions immediately. It redefines the
viewing window based on the current values of the window
variables. It adjusts in only one direction so that
@X=@Y, which
makes the graph of a circle look like a circle.
Xscl and Yscl
remain unchanged. The midpoint of the current graph (not the
intersection of the axes) becomes the midpoint of the new graph.
Zoom In,
Zoom Out
ZDecimal
ZSquare
To Next Page
Loading...
Need help?
General
