Natrix IOM
EN ISO Standard Compliance
The Natrix was developed, constructed and manufactured in compliance with the
EC Machinery Directive 2006/42/EC for incomplete machines and in sole responsibility
and complies with the following basic requirements of the Machinery Directive
(2006/42/EC): Annex I, Articles
1.1.2, 1.1.3, 1.1.5, 1.3.2, 1.3.4 and 1.5.1
Furthermore, the incomplete machinery complies with all the provisions of the Directives
for
Electrical Equipment (2006/95/EC) and Electromagnetic Compatibility (89/336/EEC)
This machinery/piece of machinery must not be put into service until the machinery
into which it is to be incorporated has been declared in conformity with
the provisions of the EC Machinery Directive, the harmonized
standards, the European standards, or the relevant national standards.
List of standards applied:
EN ISO 12100-1/2 Safety of machinery
EN 528 Rail dependent storage and retrieval equipment
EN 619 Continuous handling equipment and
systems
EN
14121-1 Risk analysis - risk assessment
EN 60204-1 Electrical equipment and controls
The manufacturer undertakes the obligation to transmit the special documentation in
electronic form to the relevant national authorities upon request. The special technical
documents as specified in Annex VII Section B have been duly created.
European Standards go to http://www.en-standard.eu
Revision Date: 12/10/2014 Page 10 of 111
To Next Page
Loading...