Natrix IOM
Part Inventory & Identification
Label Identification
Each subassembly is shipped completely assembled except typical loose parts, which are in
boxes with the subassemblies. Segregate the conveyor subassemblies by types for inventory
and ease of locating during installation.
An identification label is attached to the charged end of the
center bed of each Natrix shoe sorter.
Labels may contain the following information:
• Item number
• Description
• Job Number
• Mfg. Number
• Tag number (if specified)
• Assembler's clock number
• Date of manufacture
• QR (Quick Retrieval) Label
o Scan Code For IOM Manual
On the supports, the tag is located on the bottom side of the foot.
On special devices it is located on a convenient flat surface that is not offensive to the
appearance of the equipment but is still accessible for viewing.
These numbers can be cross-referenced against the packing list.
Loose parts are boxed and shipped separately.
You should have all conveyor sections and supports for a particular conveyor prior to
installation.
It is cost-effective to identify and procure any missing parts before they are needed for
assembly.
Small items like nuts and bolts are weigh-counted and packaged by size and type.
Revision Date: 12/10/2014 Page 26 of 111
To Next Page
Loading...