TGW Natrix - Replace Return Pulley ∅ 63.5; Replace Return Pulley ∅ 63.5 Mm [6, 7]

Natrix IOM
Replace Return Pulley
∅
63.5
Replace return pulley
∅
63.5mm [6, 7]
Remove bottom cover [1 or 2].
Remove tension from conveyor belt [3] Remove screw [4 or 5] on both sides.
Remove return pulley [6 or 7] from the profile by turning it.
Install new return pulley again in reverse order.
Revision Date: 12/10/2014 Page 106 of 111