Natrix IOM
Shaft Encoder Flex Coupling
Replace shaft encoder [4]
Loosen screws [1] and remove protective cover [2].
Loosen screws [3] and remove encoder [4] from drive shaft.
Remove coupling half [5] form shaft encoder [4].
Install new shaft encoder again in reverse order.
Recommended to change Controlflex coupling [5] at the same time.
Install new coupling again in reverse order.
Attention: The zero point must be established after new coder is installed!
Revision Date: 12/10/2014 Page 67 of 111
To Next Page
Loading...