TGW Natrix - Replace Support Roller [1]; Replace Intermediate Roller [2]; Replace Tension Spring [3]

Natrix IOM
Replace support roller [1]
Loosen screw [4] on both sides.
Remove support roller [1]
Install new support roller again in reverse order.
Replace intermediate roller [2]
Remove support roller [1].
Loosen screws [5] on both sides and remove cover [6].
Remove intermediate roller [2] by disengaging spring [3].
Install new intermediate roller again in reverse order.
Replace tension spring [3]
Remove support roller [1].
Disengage tension spring [3].
Install new tension spring again in reverse order.
Revision Date: 12/10/2014 Page 101 of 111