Natrix IOM
• After maintenance, REPLACE guards immediately.
• Keep ALL warning labels clean and clear of any
obstructions.
• Never remove, deface or paint over WARNING or
CAUTION labels. Any damaged label will be replaced by
TGW Systems at no cost by contacting Lifetime Services.
• It is very important to instruct personnel in proper
conveyor use including the location and function of all
controls.
• Special emphasis must be given to emergency stop
procedures.
• It is important to establish work procedures and access
areas which do not require any part of a person to be
under the conveyor.
• It should be required that long hair is covered by caps or
hair nets.
• Loose clothing, long hair and jewelry must be kept away
from moving equipment.
• Maintain enough clearance on each side of all conveyor
units for safe adjustment and maintenance of all
components.
• Provide crossovers or gates at sufficient intervals where
needed to eliminate the temptation for personnel to climb
over or under any conveyor.
• Walking or riding on a moving conveyor must be
prohibited.
• Before performing maintenance on the conveyor, make
sure the start-up controls are locked out and cannot be
turned on by any person other than the one performing
the maintenance.
• If more than one crew member is working on the
conveyor, EACH CREW MEMBER MUST HAVE A LOCK
ON THE POWER LOCKOUT.
• All pneumatic devices must be de-energized and air
removed to prevent accidental cycling of the device while
performing general maintenance.
• Make sure all personnel are clear of all conveyor
equipment before restarting the system.
Revision Date: 12/10/2014 Page 14 of 111
To Next Page
Loading...