Natrix IOM
• Do not perform maintenance on the conveyor until the
start-up controls, including motor safety switches, are
locked out and cannot be turned by any person other
than the one performing the maintenance.
• If more than one member of a crew is working on the
conveyor, EACH CREW MEMBER MUST HAVE A
LOCK ON THE POWER LOCK OUT. The air pressure
must be turned off to the work area. All pneumatic
devices must be de-energized to prevent accidental
cycling of the device.
• Check the loosened parts have been retightened and all
guards reinstalled.
• Make sure personnel are clear of all conveyor
equipment before restarting the system.
Revision Date: 12/10/2014 Page 80 of 111
To Next Page
Loading...