Section 4 – SR-2 Operation
STARTING THE DIESEL ENGINE
Diesel engine preheats and starts are automatic in both Continuous Mode and Cycle Sentry Mode. The engine
will preheat and start, if necessary, when the unit is turned on. The engine preheat and start will be delayed in
Cycle Sentry mode if there is no current need for the engine to run. If any keys are being pressed on the HMI
control panel the engine will not preheat and start until 10 seconds after the last key is pressed.
CAUTION: The engine may start automatically any time the unit is turned on.
WARNING: Never use starting fluid.
When the engine is preparing to start the HMI control panel will display the engine start screen, as shown below.
The preheat buzzer sounds during the engine preheat and crank sequence.
OFF
ON
DIESEL ENGINE STARTING
When the engine is started the display returns to the Standard Display of temperature and setpoint.
4-12
31 January 2005
To Next Page
Loading...
