Thermo King SR-2 SmartReefer2 - Access Code Setup Menu; Enter Access Code; Language Setup Menu; Software Revision Language Support

Section 3 – SR-2 Software Description
Language Setup Menu
This menu allows the display language to be
selected, as required. When a language is selected
all subsequent displays are in the language.
The languages available are dependent on the
software revision in the HMI control panel. Only one
of the two software revisions can be installed, and
only the languages in that revision are available.
Other than language support, there is no difference
between the software revisions. English is included
in both revisions.
HMI control panel software revisions support the
languages shown in the table below.
Software Revision Language Support
Software Revision
65xx
Software Revision
66xx
English English
Spanish Russian
French Polish
German Hungarian
Italian Romanian
Dutch Bulgarian
Portuguese Czech
Greek Danish
Turkish Swedish
Hebrew Norwegian
Arabic Finnish
Default Language
Micro Rev
All
HMI Rev
All
Choices
See Language Support Table
Factory Set
English
Exceptions
Description This feature allows the default
language to be selected. The default language is
the language shown when the unit is turned on.
There is an Enable Language screen for each
language included in the installed software revision.
English is included in both language sets and is
factory set as Enabled. Only enabled languages will
appear in the Main Menu Language selections. All
languages other than English are factory set as
Disabled. If only one language is enabled the
Language selection does not appear in the Main
Menu.
Enable Language
Micro Rev
All
HMI Rev
All
Choices
See Language Support Table
Factory Set
English only
Exceptions
Description This feature allows any or all of the
included languages to be enabled. Only enabled
languages will appear in the Operators Language
Menu. All languages other than English are factory
set as Disabled. If only one language is enabled the
Language Menu does not appear in the Main Menu.
Access Code Setup Menu
This menu allows an Access code to be required for
entry to the Guarded Access Menu. If a code is
selected, an access code challenge will appear
when entering the Guarded Access menu. If the
correct code is not entered access is denied.
A technician can bypass an unknown security code
by entering “4444” and pressing the Enter key.
Enter Access Code
The + and – keys are used to enter the desired
Access Code. The code should be recorded for
future use.
3-22
31 January 2005