Section 3 – SR-2 Software Description
Range Mode Settings
These features allow the desired operating modes to
be established for each range. The available modes
are selected for the range being programmed.
Economy Mode, Cycle Sentry Mode and Continuous
Mode are available. Any of these modes can be
turned on or off for each range, but either Cycle
Sentry or Continuous must be turned on. If more
than one mode is available in a range, it can be
selected using the Mode Menu or the Mode key.
The custom features for each range are determined
by the modes selected for that range.
• Economy Mode Only door switch
operation can be customized if Economy
Mode is allowed.
• Cycle Sentry Mode A number of Cycle
Sentry features can be customized if Cycle
Sentry mode is allowed and Economy Mode
is turned off. These features are the same
for both Frozen and Fresh ranges.
• Continuous Mode A number of
Continuous Mode features can be
customized, if Continuous Mode is allowed
and Economy Mode is turned off. These
features are different with Frozen and Fresh
ranges. They are also different if the unit is
not equipped with ETV or if modulation is
turned off.
Economy Mode
Micro Rev
All
HMI Rev
All
Choices
Off, On or Selectable
Factory Set
Off
Exceptions
Description If Economy Mode is turned on, a
relaxed set of default values are used for both Cycle
Sentry and Continuous Mode operation. This results
in increased fuel economy.
While Selectable appears in the menu, it is not
implemented and should not be used.
This feature allows Economy Mode to be turned On
or Off for the selected range.
Economy Mode default values cannot be changed.
Only door switch operation can be modified. For
details of Economy Mode operation see Section 7.
3-28
31 January 2005
To Next Page
