Section 4 – SR-2 Operation
If the electric standby power source fails or is disconnected and manual switching to diesel mode is selected, the
unit will prompt for a switch to diesel. Selecting YES will switch unit operation back to diesel mode. Pressing the
NO key will allow the unit to remain in Electric Standby mode even though standby power is not available.
OFF
ON
ELECTRIC STANDBY UNDETECTED
DO YOU WISH TO SWITCH TO
DIESEL?
NOYES
Switching from Electric to Diesel
If the unit is running in electric and manual switching to diesel mode is enabled, the unit is switched using the
Diesel Mode Menu. From the Standard Display, press the MENU key.
OFF
ON
35
°F
35
CYCLE SENTRY
.8
MENUSET SENSORSGAUGES
POINT
The Language Menu or Alarm Menu will appear. Press the NEXT key as required to show the Diesel Mode
Menu. When the Diesel Mode Menu is shown press the SELECT key.
OFF
ON
MAIN MENU
DIESEL MODE
NEXTEXIT BACKSELECT
4-51
31 January 2005
To Next Page
