160
28. RECORDING DATA - TOPO MENU -
2. Select the point name to be displayed in detail and press
[ENT].
Details of the data are displayed. This screen contains
distance measurement data.
• To display previous data item, press [PREV].
• To display next data, press [NEXT].
• Press [EDIT] to edit code/target height/point name of the
selected point name. Items that can be edited depend on
the type of data selected.
Press [OK] to confirm changes and return to the previous
screen.
• [ ] = Use {}/{} to move from page to page.
• [ ...P] = Use {}/{} to select individual point.
• Press [FIRST] to display first data.
• Press [LAST] to display last data.
• Press [SRCH] to search for point name. Input the point
name after "PT".
The search may take time if many data are registered.
• Press [RED] to display the reduced data screen shown at
right.
Press [OBS] to return to the previous screen.
3. Press {ESC} to conclude detailed display and restore the
list of points.
Press {ESC} again to restore <TOPO>.
• If more than two points with the same point name exist in the current JOB, GM finds the newer data only.
...P
To Next Page
Loading...
Need help?
General
