192
33. CHANGING THE SETTINGS
5. Press [OK] to record the allocations and restore <Key
function>.
The functions with their new allocations are displayed in
OBS mode.
PROCEDURE Registering an allocation
1. Allocate functions to the softkeys.
“PROCEDURE Allocating functions”
2. Select “Key function” in Config mode.
3. Select “Registration.”
Select either “User’1” or “User’2” as the softkey array to be
registered.
4. Press {ENT}. The softkey array is registered as user 1 or
user 2 and <Key function> is restored.
PROCEDURE Recalling an allocation
1. Select “Key function” in Config Mode.
2. Select “Recall.” Select the key array for either User 1, User
2, or Default (setting when the GM was shipped), and press
{ENT}.
<Key function> is restored. This displays the functions in the
recalled array in OBS mode.
The following explains the two methods of restoring default settings:
Restoring set items to initial settings and turning power on. Initializing the data and turning power on.
• Restore the following items to the initial settings when the GM was shipped.
EDM setting, Config mode settings (including softkey arrays)
About initial settings when the GM was shipped: "33.1 Observation Conditions - Angle/Tilt",
"33.12 Allocating Key Functions"
• Initialize the data. The following data is initialized.
Data within all jobs
Known point data within memory
Code data within memory
PROCEDURE Restoring set items to initial settings and turning power on
1. Turn the power off.
2. While pressing {F4} and {B.S.}, press the power key.
33.13 Restoring Default Settings
To Next Page
Loading...
Need help?
General
