15
5. BASIC OPERATION
Learn basic key operations here before you read each measurement procedure.
Power ON/OFF
"8. POWER ON/OFF"
Lighting up the reticle/keys
Switching to Starkey mode
"5.3 Starkey Mode"
Switching target type
Target type can be switched only on the screen where the target symbol (ex. ) is displayed.
Target symbol displayed: "5.2 Display Functions", Switching between target types in the Starkey mode:
"5.3 Starkey Mode", Switching the target type in Config mode": "33.2 Observation Conditions - Dist"
Switching the Laser-pointer/Guide light ON/OFF
"Switching { } function: "33.7 Instrument Conditions - Instrument""
• After turning ON the laser-pointer/guide light, the laser beam is emitted for 5 minutes, and then
automatically switches OFF. But in the Status screen and when target symbol (ex. ) is not displayed in
the OBS mode, the laser beam is not automatically turned off.
5.1 Basic Key Operation
{ }
Switches the reticle illumination and key light On/Off
{}
Switches to Starkey mode/previous screen
{SHIFT}
Switches between target types (Prism/Sheet/N-Prism (reflectorless))
{ } (Press and hold until a
beep sounds)
Turns ON/OFF the laser-pointer/guide light
Softkey selection
Display unit
Starkey
Power key
Illumination key
To Next Page
Loading...
Need help?
General
