176
32. USING USB FLASH DRIVE
1. Select "Save code" on the first page of the USB mode.
2. Specify a file name and press {ENT}.
Entering extension name: " PROCEDURE Data saving
step5"
3. Pressing [OK] starts saving the code. When saving is
completed, the screen returns to the list of JOBs.
Pressing {ESC} stops saving.
The known point data or code previously saved in a USB flash drive can be loaded to the current JOB.
• Only coordinate records having a file format compatible with the GM can be loaded to the GM.
Output format and command operations: "Communication manual"
PROCEDURE Reading Known Point Data
1. Select "Load known Pt." in Data mode.
2. Check the displayed current JOB name, then press [OK]
3. Select the input format.
(When T type is selected)
32.4 Loading Data in USB flash drive to the GM
USB
Save data
Load known PT
Save code
Load code
File status
Remaining memory / Total memory size
USB
Save data
Load known PT
Save code
Load code
File status
OK
Load known PT
Job.JOB1
OK
Load known PT
GTS(Coord)
SSS(Coord)
To Next Page
Loading...
Need help?
General
