152
28.RECORDING DATA - TOPO MENU -
In Record menu, you can store the measurement data (distance, angle, coordinates), station point data,
backsight station data, and note in the current JOB.
"29. SELECTING/DELETING A JOB"
• A total of 50,000 data can be stored inside the instrument. Recording instrument station data and backsight
station data is an exception.
• If the same point name is input, the following screen is displayed.
Press [ADD] to record the point as another record with the same name.
Press [NO] to input a new name.
Press [YES] to overwrite the present point.
Instrument station data can be stored in the current JOB.
• The items that can be recorded are the instrument station coordinates, point name, instrument height, codes,
operator, date, time, weather, wind, temperature, air pressure and atmospheric correction factor.
• If instrument station data is not stored for the current JOB, the previously stored instrument data settings will
be used.
PROCEDURE
1. Press [TOPO] in the third page of OBS mode to display
<TOPO>.
• Current JOB name is displayed.
2. Select “Occupy”.
28.1 Recording Instrument Station Data
ADD
TOPO JOB1
Occupy
Angle data
Dist data
Coord data
BS data
To Next Page
Loading...
Need help?
General
