163
29. SELECTING/DELETING A JOB
4. Align the cursor with the desired JOB as the current JOB
and press {ENT}.
The JOB is determined.
5. Press {ENT}.
<JOB selection> is restored.
6. Align the cursor with “Coord search JOB” and press [LIST].
<Coord search JOB> is displayed.
7. Align the cursor with the desired JOB as the coordinate
search JOB and press {ENT}.
The JOB is determined and <JOB> is restored.
• The list of JOB names is contained on up to 2 pages.
PROCEDURE Inputting a JOB name
1. Select “JOB” in Data mode.
2. Select in advance the JOB whose name to be changed.
“PROCEDURE JOB selection and scale factor setting”
3. Select “JOB details” in <JOB>. After inputting the detailed
information for the JOB, press [OK].
<JOB> is restored.
• Enter the scale factor for the current JOB.
• Maximum length of JOB name: 12 (alphanumeric)
• Scale factor input range : 0.50000000 to 2.00000000
(*1.00000000)
“*” : Factory setting
It is possible to clear the data within a designated JOB. After the data has been cleared, the JOB name returns
to the name allocated when the GM was shipped.
• A JOB that has not been output to an auxiliary device (displayed with *) cannot be deleted.
PROCEDURE
1. Select “JOB” in Data Mode.
29.2 Deleting a JOB
JO B detail s
JOB na m e
SC AL E: 1. 00 000 000
OK
JOB
JOB selection
JOB details
JOB deletion
Comms output
Comms setup
To Next Page
Loading...
Need help?
General
