EasyManuals Logo

Topcon GM-100 Series User Manual

Topcon GM-100 Series
229 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #200 background imageLoading...
Page #200 background image
194
34.WARNING AND ERROR MESSAGES
The following is a list of the error messages displayed by the instrument and the meaning of each message. If
the same error message is repeated or if any message not shown below appears, the instrument has
malfunctioned. Contact your local dealer.
BadCondition
The air is shimmering a lot, etc., measuring conditions are poor.
The center of the target cannot be sighted.
Resight the target.
Unsuitable distance measurement conditions when reflectorless measurement is set. When reflectorless
measurement is set, distance cannot be measured because the laser beam is striking at least two surfaces
at the same time.
Choose a single surface target for distance measurement.
Bad file name
File name is not entered when saving data on USB flash drive.
Calculation error
Coordinates identical to the known point coordinates observed during resection exist. Set another known
point so that the known point coordinates do not coincide.
An error occurred during calculation.
Checksum error
A sending/repetition error has occurred between the GM and external equipment.
Send/receive the data again.
Clock error
Clock error occurs when the voltage of the lithium battery decreases or the battery itself is depleted. For
details on replacing lithium batteries contact your local dealer.
Communication error
A reception error has occurred in coordinate data from an external instrument.
Check the settings of parameters concerning communication conditions.
Flash write error!
It is impossible to read in data.
Contact your local dealer.
Incorrect Password
Input password does not match set password. Input correct password.
Insert USB
USB flash drive is not inserted.
Invalid USB
Incorrect USB flash drive is inserted.
Invalid baseline
During setting-out line measurement or point projection measurement, baseline has not been defined
correctly.

Table of Contents

Other manuals for Topcon GM-100 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Topcon GM-100 Series and is the answer not in the manual?

Topcon GM-100 Series Specifications

General IconGeneral
BrandTopcon
ModelGM-100 Series
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals