169
30. REGISTERING/DELETING DATA
2. Select “Key in code”.
Enter the code and press {ENT}. The code is registered and
<Code> is restored.
• Maximum code size: 16 (alphanumeric)
• Maximum number of codes registered: 60
PROCEDURE Entering code from an external instrument
• Only the codes for communication formats compatible with "T type" can be input.
• When registering the code, it is necessary to select "T type" in the communication setting.
"33.1 Observation Conditions - Angle/Tilt" Communication Setup
1. Connect the GM and a host computer in advance.
2. Select "Code" in the Data mode.
3. Select "Comms input" and press [ENT].
Code communication starts and the number of transmitted
data is displayed. When transfer is completed, the screen
returns to <Code>.
• Pressing {ESC} stops data transfer.
PROCEDURE Deleting codes
1. Select “Code” in Data Mode.
2. Select “Deletion”. The registered code list is displayed.
Code
Key in code
Comms input
Comms output
Deletion
Code view
Code
Key in coord
Comms input
Comms output
Deletion
Code view
To Next Page
Loading...
Need help?
General
