164
Regulatory Information
The following sections provide information on this product's compliance with government regulations.
FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
NOTE:
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equip-
ment in a residential area is likely to cause harmful interference in which case the user will be required to
correct the interference at his own expense.
WARNING:
Change or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
Specified cables must be used for connection to host computer and/or peripherals in order to meet FCC
emission limits.
Declaration of Conformity
Model Number:
IS
201
/
IS
203
/
IS
205
Trade Name: TOPCON CORPORATION
Manufacture
Name: TOPCON CORPORATION
Address: 75-1, Hasunuma-cho, Itabashi-ku, Tokyo, 174-8580 JAPAN
Country: JAPAN
U.S.A. Representative
Responsible party: TOPCON POSITIONING SYSTEMS,INC.
Address: 7400 National Drive Livermore, CA94551, U.S.A
Telephone number: 925-245-8300
Means of conformity
This device complies with part 15 of the FCC Rules, Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.