88
4 STANDARD MEASUREMENT MODE
4.4.2 Setting of the Instrument Height / Reflector(Prism) Height
Measure the coordinates by entering the instrument height / reflector height, coordinates of unknown
point will be measured directly.
[Example] : Instrument height
Confirm the angle measurement mode.
1
Press the [ ] key.
2
Press the [P1] key to get on page 2.
3
Press the [INSHT] key .
The previous data will be shown.
4
Press the [INPUT] key.
5
Input instrument height, and press [SET]
key.*1)
6
Press the [EXIT] key.
The display returns to coordinate
measurement mode.
*1)To return to the previous mode, press the [EXIT] key.