Toro Multi Pro 1750 - Page 267

Multi Pro 1750 Page 7 − 41 Drive Train
11.Assemble main shaft:
A. Install gear (item 17) and snap ring.
B. Install gear (item 15).
C. Use a press to install bearing.
D. Install washer and needle bearings onto main
shaft. Apply moly disulfide grease onto washer and
needle bearings before installing. Oil groove on
washer must face the gear.
E. Install gear (item 11) and snap ring.
F. Apply clean Dexron III transmission oil on cone
face of gear and install synchro ring onto gear.
G. Insert key.
H. Install synchro hub sub−assembly.
I. Install snap ring.
J. Install synchro ring onto gear. Apply clean Dex-
ron III transmission oil to cone face of gear before
installing synchro ring.
K. Insert needle bearings into gear. Apply moly dis-
ulfide grease onto needle bearings before installing.
L. Install gear with synchro ring onto main shaft.
M. Install washer and snap ring. Apply moly disulfide
grease to washer before installing. Oil groove on
washer must face the gear.
1. Bearing
2. Snap ring
3. Washer
4. Gear
5. Needle bearing (2)
6. Synchro ring
7. Snap ring
8. Shifter
9. Key
10. Snap ring
11. Gear
12. Needle bearing (2)
13. Washer
14. Bearing
15. Gear
16. Snap ring
17. Gear
18. Main shaft
Figure 70
3 4 7 8 13 16 14
18 1 2 6 9 115121715
10
Grease
Moly Disulfide
Grease
Moly Disulfide
Transmission Oil
Dextron III
1. Bearing
2. Snap ring
3. Washer
4. Gear
5. Needle bearing (2)
6. Synchro ring
7. Snap ring
8. Shifter
9. Key
10. Snap ring
11. Gear
12. Needle bearing (2)
13. Washer
14. Bearing
15. Gear
16. Snap ring
17. Gear
18. Main shaft
1
2
3
5
4
6
8
7
10
6
11
12
13
18
9
17
16
15
14
Figure 71
Drive Train