E6582062
4-5 4. [Basic operation] Operation methods of motor
3
4
9
2 Select a parameter you want to change and press
the [OK] key.
In the example on the right, <F101: Reach signal
specified frequency> is selected.
The setting screen of that parameter is opened.
3 Change the setting of the selected parameter and
press the [OK] key.
The history function screen is displayed.
When you select the history function next time, the
parameter changed most recently is displayed on
the top.
4 Press the [ESC] key.
The screen returns to the [Setting mode] screen.
F723 : Icon areadisplay of operation paneh
F101 : Reach signal frequency
Fr : Panel Fwd/Rev run
FMOd : Frequency command select 1
CMOd : Run command select
Top
0.0HzSTOP
14:00
Monitor
History function
2.5Hz
0
10
1
0.0HzSTOP
14:01
F101 : Reach signal frequency
Min: 0.0 Max: 80.0
X1000 X100 X10 X1
Hz
2.5
0.0HzSTOP
14:01
F101 : Reach signal frequency
Min: 0.0 Max: 80.0
X1000 X100 X10 X1
Hz
0.0
F723 : Icon areadisplay of operation paneh
F101 : Reach signal frequency
Fr : Panel Fwd/Rev run
FMOd : Frequency command select 1
CMOd : Run command select
Top
0.0HzSTOP
14:01
Monitor
History function
0.0Hz
0
10
1
To Next Page
Loading...
