Toshiba TOSVERT VF-S11 User Manual

E6581158
F-4
6
6.1.3 Output of set frequency speed reach signal
H
: Speed reach setting frequency
H
: Speed reach detection band
• Function
When the output frequency becomes equal to the frequency set by H±H, an ON or OFF
signal is generated.
Q Parameter setting of frequency and detection band
Title Function Adjustment range Default setting
H
Speed reach setting frequency
0.0 ∼ HJ (Hz)
0.0
H Speed reach detection band
0.0 ∼ HJ (Hz)
2.5
Q Parameter setting of output terminal selection
Title Function Adjustment range Default setting
H
Output terminal
selection 2A (OUT-NO)
0-255
(See Section 11, K-18)
8: RCHF (designated frequency - ON
signal), or 9: RCHFN (designated
frequency - OFF signal)
Note: Select the H parameter to specify RY-RC terminal output, or set the H parameter function
No. to 8 or 9 to specify FLA-FLC-FLB terminal output.
If the detection band value + the set frequency is less than the designated frequency
Set frquency speed reach signal
RY-RO terminals
P24-OUT terminals
FLA-FLC-FLB terminals
Set frequency speed reach signal:
Inverted
Output frequency [Hz]
Time [s]
H
- H
ON
OFF
H + H
H
ON
OFF
0

Toshiba TOSVERT VF-S11 Specifications

General

Model	TOSVERT VF-S11
Category	Inverter
Output Frequency	0.1-400Hz
Frequency Range	0.1-400Hz
Control Method	V/f Control, Sensorless Vector Control
Power Rating	0.2kW to 15kW
Cooling Method	Forced air cooling
Overload Capacity	150% for 60 seconds
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overheat
Communication	Modbus RTU
Input Voltage	200-240V, 380-480V
Braking Unit	Built-in (optional external braking resistor)