Preparing the T2-C press for transportation
110 T2-C User Guide
Storing used or opened printheads
Use a clean, lint-free microfiber cloth moistened (not dripping) with clean DI water to do a single
pass cleaning of the nozzles using light to no pressure.
Keep ink coupling in upright position to avoid ink dropping down. Secure the original orange
protective printhead cover onto the printhead.
Place a clean moistened lint free cloth into a zipper bag along with the orange covered
printhead. Ensure printhead is packaged securely to avoid damage (in box with flat orientation).
Caution: DO NOT touch the printhead cartridge's ink couplings, nozzle surface or the
electrical contacts when installing the printhead cartridge. Hold the printhead cartridge ONLY
by the handles.
Caution: DO NOT unpack the printhead cartridge until the printer is ready for installation. Once
unwrapped, delay in installing the printhead can compromise print quality due to dehydration.
Caution: DO NOT place an unwrapped printhead on any surface before installing. Protect the
printhead at all times from dust, fibers, dirt and other contaminants.
To Next Page
Loading...
Need help?
General